Solar Technology – EP MPPT™ 600V CHARGE CONTROLLER
Morningstar’s TriStar MPPT 600V Charge Controller can be used with higher voltage photovoltaic (PV) arrays, wind turbines or hydropower systems. This product enables the following application scenarios: • Adding modules incrementally with no string sizing issues • Off-grid PV, wind or hydro systems with input voltages greater than 150V • Fewer combined circuits and lower current for long wire runs from the array to the controller • New installation grid-tie PV systems with battery back-up • Retrofitting grid-tie PV systems to include battery back-up without changing the PV array configuration • Supplementary charging for AC Coupled PV systems.
- Description
Description
Morningstar’s TriStar MPPT 600V Charge Controller can be used with higher voltage photovoltaic (PV) arrays, wind turbines or hydropower systems. This product enables the following application scenarios: • Adding modules incrementally with no string sizing issues • Off-grid PV, wind or hydro systems with input voltages greater than 150V • Fewer combined circuits and lower current for long wire runs from the array to the controller • New installation grid-tie PV systems with battery back-up • Retrofitting grid-tie PV systems to include battery back-up without changing the PV array configuration • Supplementary charging for AC Coupled PV systems.
Four Versions:
TS-MPPT-60-600V-48 Standard
TS-MPPT-60-600V-48-DB With Disconnect Box (600V; 25A 1-Pole disconnect switch)
TS-MPPT-60-600V-48-DB-TR* With DC Transfer Switch (600V; 30A double pole; double throw DC Transfer Switch)
TS-MPPT-60-600V-48-DB-TR-GFPD
** Pre-wired with Ground Fault Protection Device All non-standard versions include a 1-Pole; 63A PV battery breaker*** and pre-wired PV/Battery busbars TR versions also include a pre-wired String Inverter busbar
Technical Specifications
Electrical
- Peak Efficiency 97.9%
- Maximum Battery Current 60A
- Maximum Input Operating Current 15A (self limiting)
- Maximum Solar Open Circuit Voltage 600V
- Nominal Maximum Operating Power**** 3200Wp, 48 Volt
- Nominal System Voltage 48 Vdc custom programmable to 24V, 36V and 60V
- Battery Operating Voltage Range 16-72 Vdc
- PV Input Operating Voltage Range 100V to Voc = 525V
- Wind/Hydro Input Operating Voltage Range Battery Voltage to 500V
- Self-Consumption 1.75 – 2.50 W
- Transient Surge Protection 4500 Watts/port
Mechanical
Dimensions
- Standard Version 39.2 x 22.1 x 14.9 cm / 15.4 x 8.7 x 5.9 in
- DB & TR Version 54.2 x 22.1 x 14.9 cm / 21.4 x 8.7 x 5.9 in
Unit Weight
- Standard Version 9.0 kg / 19.8 lbs
- DB & TR Version 12.8 kg / 28.1 lbs
Maximum Wire Size
- Power Terminals 2.5 mm2 – 35 mm2 / 14 AWG – 2 AWG
- RTS/Sense Terminals 0.25 mm2 – 1.0 mm2 / 24 AWG – 16 AWG
Conduit Knockouts
- M20; 0.50, 1.00, 1.25 inches
Enclosure Rating
- Enclosure Rating Type 1 (indoor and vented), IP20